This section describes the bytes that are sent to the U12 over USB. Most users are going to use the functions provided by the UW driver (Section 4).
This section is a valuable resource for anyone looking to interact directly with the U12.
Note that the LabJack U12 does not respond to the first command.
On the description of the commands, an ‘X’ means that the bit is ignored and can be set to either 0 or 1.
Subsections
-
5.1 - AISample [U12 Datasheet] -
5.2 - DIO [U12 Datasheet] -
5.3 - Counter [U12 Datasheet] -
5.4 - Counter/AO/DIO [U12 Datasheet] -
5.5 - AIBurst [U12 Datasheet] -
5.6 - AIContinuous [U12 Datasheet] -
5.7 - Pulseout [U12 Datasheet] -
5.8 - Reset [U12 Datasheet] -
5.9 - Re-Enumerate [U12 Datasheet] -
5.10 - Watchdog [U12 Datasheet] -
5.11 - Read RAM [U12 Datasheet] -
5.12 - Write RAM [U12 Datasheet] -
5.13 - Asynch [U12 Datasheet] -
5.14 - SPI [U12 Datasheet] -
5.15 - SHT1X [U12 Datasheet]